Gas Monitor
Total Analytical Solution 
D-2-4, Setia Walk, Pusat Bandar Puchong,
47160 Puchong, Selangor, Malaysia
 
Tel: + 6012-921 3877; 603-5879 7121
Fax: +018 635 1593
Email: ancor.my@gmail.com
            sales@gasmonitors.com.my
   Home      Drager- Drager Polytron 5200
 
 

Dräger Polytron 5200

 
Quick, reliable and cost-effective detection of combustible gases and vapors in ambient air: the microprocessor-based transmitter is the result of more than 40 years of experience in measurement technology. In addition, the CatEx sensor of the Polytron 5200 DD can be replaced with a more poison-resistant IR sensor, upgrading the Polytron 5200 DD to an IR device (Polytron 5310).
 

Proven – and still getting better: Dräger Measurement Technology

Dräger has been developing and manufacturing sensors and gas detectors for industrial use for more than 40 years. And with each new generation, we drive our measurement technology a bit further. With the Polytron 5200, you will definitely benefit from this experience and power of innovation. Its new DrägerSensor Ex PR DD or Ex PR LC, for example, ensures:

 

  • longer lifetime
  • better poison resistance
  • extremely high sensitivity
  • short response times
  • high accuracy
  • stable sensor signal
 
 

Easy and cost-effective: Single-operator calibration

The transmitter settings can be changed and maintenance carried out without opening the housing. Declassification of the hazardous, classified area is not necessary. Use the magnetic wand to quickly and easily select menu items and functions. An additional hand held terminal is not required. The sensor contains an integrated database where all important information is stored. This enables you to use pre-calibrated sensors.​
 
 

Optional: Two mounting sets for easy flange-mounting

The housing has four mounting holes. Two different mounting sets are available for installing the Polytron 5000: a duct-mount and a pipe mount set. This means that the transmitter can be easily installed anywhere – e.g., on a smooth wall, a pipe or an exhaust duct.
 
 

Quick and easy wiring

​The electronics and the bezel form a single unit. Simply pull them out of the housing. Then insert the three-wire cable into the terminals – either through the Ex-e cable gland or through the seal on the conduit. Finally, plug the terminal block into the PCB.
 
 

Further advantages

  • ​Available as flameproof or increased safety version
  • Aluminum or 316 L stainless steel housing for the most extreme industrial conditions
  • Extremely user-friendly software thanks to a minimum number of menu items
  • Backlit display: easy to read, even in the dark and without a flashlight
  • Traffic light status indicators (green = no danger, yellow = error, flashing red = gas alarm)
  • Can also be used as an early warning system (0–10 % LEL) for ammonia
 
 
 
 
 
D-2-4, Setia Walk, Pusat Bandar Puchong,
47160 Puchong, Selangor, Malaysia

Tel: + 6012-921 3877; 603-5879 7121
Fax: +018 635 1593
Email: ancor.my@gmail.com 
           sales@gasmonitors.com.my