Gas Monitor
Total Analytical Solution 
D-2-4, Setia Walk, Pusat Bandar Puchong,
47160 Puchong, Selangor, Malaysia
 
Tel: + 6012-921 3877; 603-5879 7121
Fax: +018 635 1593
Email: ancor.my@gmail.com
            sales@gasmonitors.com.my
   Home      Drager- Drager Polytron 5310
 
 

Dräger Polytron 5310

 
 
Quick, reliable and cost-effective detection of combustible gases and vapors in ambient air: the microprocessor-based Polytron 5310 transmitter is the result of more than 40 years of experience in measurement technology and contains a durable, poison-resistant IR sensor.
 

Proven – and still getting better: Dräger measurement technology

Dräger has been developing and manufacturing sensors and gas detectors for industrial use for more than 40 years. And with each new device generation, we drive our measurement technology a bit further. With the Polytron 5310, you will definitely benefit from this experience and power of innovation:
  • durable sensors
  • short response times
  • high sensitivity
  • high accuracy
  • low sensitivity to changing ambientconditions
 

Optional: two mounting sets for easy flange-mounting

The housing has four mounting holes. Two different mounting sets are available for installing the Polytron 5310: a duct-mount and a pipe mount set. This means that the transmitter can be easily installed anywhere – e.g., on a smooth wall, a pipe or an exhaust duct.
 
 

Easy and cost-effective: single-operator calibration


The transmitter settings can be changed and maintenance carried out without opening the housing. Declassification of the hazardous, classified area is not necessary. Use the magnetic wand to quickly and easily select menu items and functions. Anadditional hand held terminal is not required
 
 
 

Optional: three relays for controlling external equipment

Upon request, the Dräger Polytron 5310 can be supplied with three integrated relays. This enables you to use it as an independent gas detection system with two arbitrarily adjustable concentration alarms and one fault alarm. Audio alarms, signal lights, or similar devices can, thus, be controlled locally – without an additional cable between the transmitter and a central controller. The sensor signal can be evaluated using the 4 to 20 mA signal.
 
 

Quick and easy wiring

The electronics and the bezel form a single unit. Simply pull them out of the housing. Then insert the three-wire cable into the terminals – either through the Ex-e cable gland or through the seal on the conduit. Finally, plug the terminal block into the PCB.
 
 

Further advantages:

  • Available as flameproof or increased safety version
  • Aluminum or 316 L stainless steel housing for the most extreme industrial conditions
  • Extremely user-friendly software thanks to a minimum number of menu items
  • Backlit display: easy to read, even in the dark and without a flashlight
  • Traffic light status indicator (green = no danger, yellow = error, flashing red = gas alarm)
 
 
 
 
 
 
 
 
 
D-2-4, Setia Walk, Pusat Bandar Puchong,
47160 Puchong, Selangor, Malaysia

Tel: + 6012-921 3877; 603-5879 7121
Fax: +018 635 1593
Email: ancor.my@gmail.com 
           sales@gasmonitors.com.my