EC28 Transmitter

For toxic gases, oxygen and hydrogen

Superior technology
Wherever gas hazards are to be found, the EC28 provides the best solution for safe monitoring. ATEX-certified design, built-in EX-certified horn and bright LED lights allow safe operation. The gas alarm is transmitted to the central control panel, simultaneously warning the control room and the worker in the danger area.

Smart sensor technology
Installation and sensor exchange are quick and easy using pre-calibrated smart, plug-in sensors. One-man calibration/ adjustment is possible directly at the transmitter, without opening the housing.

Versions for each application

EC28 basic unit

EC28 D with additional display of gas concentration

EC28 DA with additional bright LED lights and loud horn. The extra costs for installing an EX-certified horn and audible alarm are omitted

EC28 DAR with additional external alarm relay

EC28 B with additional bus connection

EC28 DB with additional display of gas concentration

EC28 DAB with additional bright LED lights and loud horn. The extra costs for installing an EX-certified horn and audible alarm are omitted

EC28 i intrinsically safe version

EC28 Di instrinsically safe, with additional display of gas concentration

The advantages at a glance

Three choices – no display with display or with display and built-in audible and visual alarms
ATEX-Certification II 1G EEx ia IIC T4/ II 2G EEx em [ib] IIC T4
BVS 04 ATEX E 132 X / BVS 04 ATEX E 132 X 0158
Ex-certified visual and loud acoustic alarm
Less wiring required
Simple sensor exchange using smart, plug-in sensors
Long sensor lifetime
Low maintenance costs
Status and function display directly on the transmitter
One-man calibration/ adjustment without opening casing
Operation possible in inaccessible places via remote control (option)

Remote control (option)

Some flammable gases are lighter than air (e.g. methane). If a transmitter is installed close to the ceiling, it can be connected by a fixed installed cable with a plug connection to the remote control. Thus, all adjustments can be made comfortably from floor level. With one remote control device, an unlimited number of transmitters can be controlled in this way.

Using transmitters without display, the remote control shows the current values on its’ own display. The display of the remote control mimics the transmitter display exactly. Inspection, maintenance and adjustment are therefore greatly simplified. Using the remote control inspection, service and calibration can be performed easily by one person.